A blog of a variety of projects
Projects that involve 3D printing at some point.
We have a train-station-style Ikea wall clock that I really like, but it chews through batteries pretty fast, at least on one side. There are actually 2 clock mechanisms back-to-back, so they were mercifully designed to be smooth and not clicky. On the other hand, that means it doesn’t fail…
This is a simple little shim to help mount a door hinge slightly further away from the door frame stop moulding.
Since we have moved in to our new house, I have been putting off finishing the kitchen cabinets with trim. I finally got around to working on it and finished the floor molding. First, there is a gap between the pantry and the wall. The wall wasn’t plumb, so we…
Now with additional food safety! Fuiyoh!
This was a long time ago now, but we have been too busy on uninteresting repair projects for me to be able to keep up with blogging. I started writing this near the end of last year, when our kitchen was nearly done. We have been living with it at…
I was looking around our house for things to fix, and I saw a lot of places where there was a small hole in the drywall caused by a door handle. I was going to patch all of these with drywall, but I knew it would eventually happen again, even…
After receiving some feedback and doing additional testing, I designed a new version of my Ikea Tertial pegboard mount that is much stronger and easier to print.
Over the last couple months I have been brewing a triple-berry hard cider from ingredients easily available at the grocery store. I loosely followed an easy recipe that I have used before, but this time I kegged the cider in a kegerator I bought on Facebook marketplace instead of bottling…
Closet doors are often built with dummy doorknobs that look and feel like a normal doorknob without the internal pieces that would rotate and move a latch. They usually look just like the normal handle but they can only be installed on a door without a hole because you use…
I bought a PineTime smartwatch a long time ago, and started using it more recently. I charge it next to my bed, and the charging cradle would occasionally end up on the floor with the watch disconnected in the morning. The PineTime charging cradle is very nice, but I was…
